Joining cables is a crucial process for creating the
desired network of electrical wires. Heat shrink cable jointing kits in Dubai are the safest and most efficient
way to ensure that each joint is held together properly. Many items in a heat
shrink cable jointing kit must be used at appropriate times to ensure that the
cable joint is strong.
So, let us look at a step-by-step guide for using heat shrink cable jointing kits.
How to Use Heat Shrink Cable
Jointing Kits
Clean the Cables
The
first step in using heat shrink cable jointing kits is to ensure that each
cable is free of dirt, grease, or any other waste material. These materials can
affect how the electricity runs through these cables, so this step should
always be performed first before starting the cable joining process. In Dubai,
people can use a dry rag or alcohol wipes to clean each wire.
Cut the Insolation
After
the cables have been cleaned, the next step requires the cutting of the
insolation on the wires present inside the cable. Once exposed, check the size
of the wires and match that with the appropriate size of the connector in your
heat shrink cable jointing kit.
There
are different sized connectors that you will find inside a heat shrink cable
jointing kit in Dubai which are suited for different kinds of cables.
Connect the Wires
Once
you have located the right connector for your cables, you can apply the
connector provided in your heat shrink
cable jointing kit to hold the wires in place. If you are using a crimp
connector, use the crimping tools provided to secure the connection between the
connector and the conductor. If soldering is your choice, then twist the
conductors together and use the soldering iron to bind both of them.
Slide the Heat Shrink Tubing
After
you have held the connection together with your connector, you have to slide
the heat shrink tubing provided with your
heat shrink cable jointing kit on one of the cables. Once you have
completed connecting your cables, ensure that the tube covers your entire
connection area.
Make
sure to do this before connecting the wires. If your kit has come with a
sealant strip, wrap it around the wires before putting on the heat shrink
tube.
Heat the Tubing and Allow It
to Cool Down
Finally,
heat the tubing using your heat gun or gas torch, until it tightly shrinks
around the joint. Remember to heat the tube evenly to distribute the heat
evenly across entire tube. The exact time will vary, but the process should not
take more than a couple of minutes. Once it has cooled down, check the tube for
any gaps or loose areas.
Do
not forget to test the connections to see if they function properly. If they
work, applying some insulation tape on the joint will provide additional
protection.
If you are in search of a heat shrink cable jointing kit, visit Customer Delight Trading online today
